Home | | Physics For Civil Engineering | | Engineering Physics I | Magnetostriction Method: Principle, Construction, working, Advantages and Limitations

Chapter: Physics - Acoustics and Ultrasonics

Study Material, Lecturing Notes, Assignment, Reference, Wiki description explanation, brief detail

Magnetostriction Method: Principle, Construction, working, Advantages and Limitations

Principle: When a rod of ferromagnetic material like nickel is magnetized. Longitudinally, it undergoes a very small change in length. This is called Magnetostriction effect.

Production of Ultrasonic waves

Principle: When a rod of ferromagnetic material like nickel is magnetized. Longitudinally, it undergoes a very small change in length. This is called Magnetostriction effect.


Construction:

The circuit diagram of magnetostriction ultrasonic generator is as shown in the figure1.3.2. A short permanently magnetized nickel rod is clamped in the middle between two knife edges. A coil L1 is wound on the right hand portion of the rod. C is a variable capacitor. L1 and C1 form the resonant circuit of the collector-tuned oscillator. Coil L2 wound on the LHS of the rod is connected in the base circuit. The coil L2 is used as a feed back loop.


Working:

When the battery is switched on, the resonant circuit L1C1 sets up an alternating current o frequency.


This current lowing round the coil L1 produces an alternating magnetic iels of frequency f along the length of the nickel rod. The rod starts vibrating due to magnetostrictive effect. The vibrations of the rod create ultrasonic waves.

The longitudinal expansion and contraction of the rod produces an E.M. in the coil L2. This e.m.f is applied to the base of the transistor. Hence the amplitude of high frequency of high oscillations in coil L1 is increased due to positive feedback.

The developed alternating current frequency can be turned with the natural frequency of the rod by adjusting the capacitor.

Condition for Resonance:

Frequency of the oscillator circuit = Frequency of the vibrating rod



Where ‘l’ is the length o the rod

‘E’ is the Young’s modulus o the rod

‘ρ’ is the density of the material of the rod.

The resonance condition is indicated by the rise in the collector current shown in the milliammeter.

Advantages:

Magnetostriction Oscillators are mechanically rugged.

The construction cost is low.

They are capable of producing large acoustical power with fairly good efficiency.

Limitations

It can produce frequencies up to 3MHz only.

They frequency o oscillation depends upon the temperature.

Breadth o the resonance curve is large. It is due to vibrations of elastic constants of ferromagnetic material with the degree of magnetization. So we cannot get a constant single frequency.



Study Material, Lecturing Notes, Assignment, Reference, Wiki description explanation, brief detail


Copyright © 2018-2020 BrainKart.com; All Rights Reserved. Developed by Therithal info, Chennai.