Home | | Unconventional Machining Processes | Abrasive Jet Machining (AJM)

Chapter: Mechanical : Unconventional machining process : Mechanical Energy Based Processes

Abrasive Jet Machining (AJM)

In Abrasive Jet Machining (AJM), abrasive particles are made to impinge on the work material at a high velocity. The high velocity abrasive particles remove the material by micro-cutting action as well as brittle fracture of the work material.

ABRASIVE JET MACHINING (AJM)

 

In Abrasive Jet Machining (AJM), abrasive particles are made to impinge on the work material at a high velocity. The high velocity abrasive particles remove the material by micro-cutting action as well as brittle fracture of the work material.

 

In AJM, generally, the abrasive particles of around 50 μm grit size would impinge on the work material at velocity of 200 m/s from a nozzle of I.D. of 0.5 mm with a standoff distance of around 2 mm. The kinetic energy of the abrasive particles would be sufficient to provide material removal due to brittle fracture of the work piece or even micro cutting by the abrasives.



 

1. Process Parameters and Machining Characteristics

 

Abrasive: Material – Al2O3 / SiC / glass beads

 

Shape – irregular / spherical

 

Size – 10 ~ 50 μm

 

Mass flow rate – 2 ~ 20 gm/min

 

Carrier gas: Composition – Air, CO2, N2

 

Density – Air ~ 1.3 kg/m3

 

Velocity – 500 ~ 700 m/s Pressure – 2 ~ 10 bar

 

Flow rate – 5 ~ 30 lpm

 

Abrasive Jet : Velocity – 100 ~ 300 m/s

 

Mixing ratio – mass flow ratio of abrasive to gas

 

Stand-off distance – 0.5 ~ 5 mm

 

Impingement Angle – 60 ~     90

 

Nozzle: Material – WC

 

Diameter – (Internal) 0.2 ~ 0.8 mm

 

Life – 10 ~ 300 hours

 

.2. Modeling of material removal

 

Material removal in AJM takes place due to brittle fracture of the work material due to impact of high velocity abrasive particles.

 

3. Modeling has been done with the following assumptions:

 

(i)  Abrasives are spherical in shape and rigid. The particles are characterized by the mean grit diameter

 

(ii) The kinetic energy of the abrasives are fully utilized in removing material

 

(iii) Brittle materials are considered to fail due to brittle fracture and the fracture volume is considered to be hemispherical with diameter equal to choral length of the indentation

 

(iv) For ductile material, removal volume is assumed to be equal to the indentation volume due to particulate impact

 

 

Study Material, Lecturing Notes, Assignment, Reference, Wiki description explanation, brief detail
Mechanical : Unconventional machining process : Mechanical Energy Based Processes : Abrasive Jet Machining (AJM) |


Privacy Policy, Terms and Conditions, DMCA Policy and Compliant

Copyright © 2018-2024 BrainKart.com; All Rights Reserved. Developed by Therithal info, Chennai.