Home | | Unconventional Machining Processes | Laser–Beam Machining and Laser beam cutting (milling)

Chapter: Mechanical : Unconventional machining process : Thermal Energy Based Processes

Laser–Beam Machining and Laser beam cutting (milling)

Laser-beam machining i s a thermal material-removal process that utilizes a high-energy, Coherent light beam to melt and vaporize particles on the surface of metallic and non-metallic work pieces.

Laser–Beam Machining

 

Laser-beam machining i s a thermal material-removal process that utilizes a high-energy, Coherent light beam to melt and vaporize particles on the surface of metallic and non-metallic work pieces. Lasers can be ussed to cut, drill, weld and mark. LBM is particularly suitable for making accurately placed hol es. A schematic of laser beam machining is s hown in Figure

 

Different types of lasers are a vailable for manufacturing operations which are as follows:

 

       CO2 (pulsed or continuous wave): It is a gas laser that emits light in the infrared region. It can provide up to 25 kW in continuous-wave mode.

        Nd:YAG: Neodymium -doped Yttrium-Aluminum-Garnet (Y3Al5O 12) laser is a solid- state laser which can deliver light through a fibre-optic cable. It c an provide up to 50 kW power in pulsed m ode and 1 kW in continuous-wave mode.


Figure: Laser beam machining schematic

 

Applications

 

LBM can make very accurate holes as small as 0.005 mm in refractory metals ceramics, and composite material without warping the work pieces. This process is used widely for drilling

 

Laser beam cutting (drilling)

 

        In drilling, energy transferred (e.g., via Nd YAG laser) into the workpiece melts the material at the point of contact, which subsequently changes into a plasma and leaves the region.

        A gas jet (typically, oxygen) can further facilitate this phase transformation and departure of material removed.

 

        Laser drilling should be targeted for hard materials and hole geometries that are difficult to achieve with other methods.

 

A typical SEM micrograph hole drilled by laser beam machining process employed in making a hole is shown in Figure


Figure: SEM micrograph hole drilled in 250 micro meter thick Silicon Nitride with 3rd harmonic Nd: YAG laser

 




Laser beam cutting (milling)

 

        A laser spot reflected onto the surface of a workpiece travels along a prescribed trajectory and cuts into the material.

        Continuous-wave mode (CO2) gas lasers are very suitable for laser cutting providing High-average power, yielding high material-removal rates, and smooth cutting surfaces 

Advantage of laser cutting

 

        No limit to cutting path as the laser point can move any path.

 

         The process is stress less allowing very fragile materials to be laser cut without any support.

 

        Very hard and abrasive material can be cut.

 

        Sticky materials are also can be cut by this process.

 

        It is a cost effective and flexible process.

 

        High accuracy parts can be machined.

 

        No cutting lubricants required

 

        No tool wear

 

        Narrow heat effected zone

 

 

Limitations of laser cutting

 

         Uneconomic on high volumes compared to stamping

 

         Limitations on thickness due to taper

 

         High capital cost

 

         High maintenance cost

 

         Assist or cover gas required

 

 


Study Material, Lecturing Notes, Assignment, Reference, Wiki description explanation, brief detail
Mechanical : Unconventional machining process : Thermal Energy Based Processes : Laser–Beam Machining and Laser beam cutting (milling) |


Privacy Policy, Terms and Conditions, DMCA Policy and Compliant

Copyright © 2018-2023 BrainKart.com; All Rights Reserved. Developed by Therithal info, Chennai.